cg on 3dfoamy Katana S (Full Version)

All Forums >> [Electric Aircraft Universe] >> 3D Electric Flying!



Message

kwiktsi -> cg on 3dfoamy Katana S (7/10/2004 5:20 AM)

Hey guys, I just got done cutting out and building my Katana S. Anyone who has done one- where is the best place to start for the CG? I am completely inexperienced in 3D flying, so I figured this would be a good practice plane :). Thanks.
Joe



3dandpatternflyer -> RE: cg on 3dfoamy Katana S (7/10/2004 4:42 PM)

i've had one, just right on the spar or a little bit behind it. [;)]

TTYL,
Andrew T.



Chris-B-chips -> RE: cg on 3dfoamy Katana S (7/10/2004 10:51 PM)

i have myne on the hinge line that way i don't nedd down elevator when inverted but i would prefer it a ;ittle more forward for rolling circles and stuff.



kwiktsi -> RE: cg on 3dfoamy Katana S (7/12/2004 3:34 AM)

Thanks guys. I have it about half way between the spar and the hinge line and it seems to work ok there. I am new to 3D, so I wouldn't know and better anyway :). I know with my e flight park 370 5400 kv motor, 11.47 prop and a 3 cell lipo- it has ridiculous vertical!!!
Joe



3dandpatternflyer -> RE: cg on 3dfoamy Katana S (7/13/2004 2:52 AM)

try a 12x6 and u'll go CRAZY!!! i had the same setup [:D][:D][:D][:D][:D][:D][:D][:D][:D]



Page: [1]

Valid CSS!




SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.
0.171875