RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Crius
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: RC Tanks
06-02-2018, 02:09 PM
Replies: 23
Views: 1,746
Posted By Crius

Send your address by Private Message.

Send your address by Private Message.
Forum: RC Tanks
06-02-2018, 12:44 PM
Replies: 23
Views: 1,746
Posted By Crius

I think this is the set you need, perhaps Erik...

I think this is the set you need, perhaps Erik can confirm that? The short shaft is only in the photo to demonstrate that the shafts with gears are the longer, 58mm shafts, and of course the gears...
Forum: RC Tanks
06-01-2018, 12:14 PM
Replies: 23
Views: 1,746
Posted By Crius

The skirts aren't permanently attached and pop...

The skirts aren't permanently attached and pop right off if you want to run without them. I think I like it better without skirts, too, so it's nice to have the option.

2260780
Forum: RC Tanks
06-01-2018, 07:27 AM
Replies: 23
Views: 1,746
Posted By Crius

She's alive and well. I just got the skirts on...

She's alive and well. I just got the skirts on her so she's almost ready for paint.
Forum: RC Tanks
05-29-2018, 08:16 AM
Replies: 23
Views: 1,746
Posted By Crius

Erik, the JT uses the 58 mm shaft, right? I might...

Erik, the JT uses the 58 mm shaft, right? I might have one at home I can send him, I'll check it out when I get home from work.
Forum: RC Tanks
05-22-2018, 08:19 AM
Replies: 23
Views: 1,746
Posted By Crius

Where are you located? If you're close I might be...

Where are you located? If you're close I might be able to just send you a new axle shaft with gear attached. It's not a very big job to swap out an axle shaft. I've done it plenty of times when I...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.