RCU Forums - Search Results

Search: Posts Made By: Xpress

Showing results 1 to 5 of 5
Search took 0.01 seconds.

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

07-17-2018, 01:21 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By Xpress

HS-5485HB is discontinued so you'll be hard...

HS-5485HB is discontinued so you'll be hard pressed to find NIB out there. It's been replaced by the D-485HW which accepts a wider voltage input, runs up to 4096 resolution, has soft start, and a...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-23-2018, 02:46 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By Xpress

This is an extremely confusing one, I dare say...

This is an extremely confusing one, I dare say you may have received a defective HPP-21, but there's just no possible way 14 servos in a row were bad. Consider me completely stumped..

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-17-2018, 01:24 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By Xpress

What Futaba receiver are you using? There are a...

What Futaba receiver are you using? There are a couple that can only be used with extremely high refresh rate servos of which the HS-5485HB is not. The fact that you say your 72mhz system works fine...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-12-2018, 02:31 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By Xpress

We have never recommended a 5 cell battery to be...

We have never recommended a 5 cell battery to be used with the HPP-21, roughly 6 volts is its maximum operating voltage. My best guess is that you're pushing too much voltage to the HPP-21 which is...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-10-2018, 12:13 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By Xpress

What voltage are you operating the servos at? 2...

What voltage are you operating the servos at? 2 servos in a row to have the same issue is exceedingly rare.

Showing results 1 to 5 of 5