RCU Forums - Search Results

Search: Posts Made By: RC_Fanatic

Showing results 1 to 7 of 7
Search took 0.01 seconds.

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-26-2018, 12:56 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By RC_Fanatic

I am stumped as well. I've gone through the setup...

I am stumped as well. I've gone through the setup on the transmitter a number of times and the problem does not reappear. There were three used 5485's installed in the plane, along with 3 analog...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-19-2018, 03:04 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By RC_Fanatic

The situation has gone from frustrating to...

The situation has gone from frustrating to confusing, which I guess is an improvement. The good news is that it’s working. The bad news is that I’m not sure why. Some of that is below. Sorry for the...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-15-2018, 11:14 AM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By RC_Fanatic

Just to add to the confusion (and perhaps provide...

Just to add to the confusion (and perhaps provide an answer), I tried out three of the servos on my older Futaba 72MHz system. They work as they should. I'm now wondering if the 5845 is one of those...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-12-2018, 03:27 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By RC_Fanatic

I'll give it a try (if I can find a 4 cell pack),...

I'll give it a try (if I can find a 4 cell pack), but the servos exhibited the same behavior with two different radio systems with 5-cell batteries. That's what started me checking them out with the...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-10-2018, 03:30 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By RC_Fanatic

Using a 5-cell NiMH battery. During the tests, I...

Using a 5-cell NiMH battery. During the tests, I measured the voltage at the pins from 6.43 to 6.48 volts. Tested all 11 of my NIB servos and they all show the same problem. The HPP-21 sees them as...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-07-2018, 02:14 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By RC_Fanatic

Just to add to the problem, two of the four new...

Just to add to the problem, two of the four new servos I tested are not recognized as digital servos by the HPP-21 tester/programmer. I do notice that some of the internal electronics are working as...

Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service

01-06-2018, 02:53 PM

Replies: 12

HS-5485HB Problem

Views: 2,139

Posted By RC_Fanatic

HS-5485HB Problem

Was setting up a new plane with a Futaba receiver. Initially installed a couple of HS-5485HB from a previous plane, but they would not operate properly. They would twitch a bit, then nothing. Thought...

Showing results 1 to 7 of 7