RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: kenverret
Showing results 1 to 6 of 6
Search took 0.02 seconds.
Forum: RC Warbirds and Warplanes
02-16-2022, 06:32 AM
Replies: 787
Views: 270,819
Posted By kenverret

I would think a higher kv motor would be better...

I would think a higher kv motor would be better suited. You could run a smaller prop for better ground clearance.

See my post #633. I'm still flying it. It's my favorite warbird.
I used 2 - 2...
Forum: RC Warbirds and Warplanes
05-11-2021, 05:39 AM
Replies: 787
Views: 270,819
Posted By kenverret

Blackwidow See my post #633 that may help. I...

Blackwidow
See my post #633 that may help. I still fly it regularly. One of my favorite.

KAV
Forum: RC Warbirds and Warplanes
10-20-2018, 02:18 PM
Replies: 787
Views: 270,819
Posted By kenverret

mikeps See my post #633. 130mm for the cg...

mikeps

See my post #633. 130mm for the cg is good. It flys with a good bit of down elevator trim. I believe that the incidence is off somewhere. I almost added some down thrust to the motor...
Forum: RC Warbirds and Warplanes
04-07-2018, 06:02 AM
Replies: 787
Views: 270,819
Posted By kenverret

I finally got mine flying recently. Fly's great. ...

I finally got mine flying recently. Fly's great. weight 22lbs. 8oz of nose weight. Balance @130mm from leading edge.
Rimfire 50cc
Castle 160 ESC.
12S 2 5000 6 cell thp packs
3 blade 18x10...
Forum: RC Warbirds and Warplanes
12-20-2017, 02:07 PM
Replies: 787
Views: 270,819
Posted By kenverret

I'm almost finished with my assembly. I don't...

I'm almost finished with my assembly. I don't know what that donut is for either. I replaced the elevator pushrod with a fiberglass one. The wood and long metal rods were too flimsy for my liking. ...
Forum: RC Warbirds and Warplanes
10-29-2017, 08:06 AM
Replies: 787
Views: 270,819
Posted By kenverret

Does anyone know where I can find a flow through...

Does anyone know where I can find a flow through spinner for this spitfire, Will be setting up for Electric power.
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.