RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: DH106
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: JetCat Turbine Direct Support
02-29-2020, 09:49 AM
Replies: 12
Views: 2,232
Posted By DH106

Wonderful - thanks Dave :-)

Wonderful - thanks Dave :-)
Forum: JetCat Turbine Direct Support
02-28-2020, 06:54 AM
Replies: 12
Views: 2,232
Posted By DH106

Okay - gimmie clear if you have it Dave,...

Okay - gimmie clear if you have it Dave, otherwise yellow.
Forum: JetCat Turbine Direct Support
02-28-2020, 05:57 AM
Replies: 12
Views: 2,232
Posted By DH106

Thanks Dave - have ordered some 3mm tubing & a...

Thanks Dave - have ordered some 3mm tubing & a few other bits n bobs.
Shame they don't do clear/transparent tubing - so you can see if there's fuel in.
Forum: JetCat Turbine Direct Support
02-27-2020, 10:13 PM
Replies: 12
Views: 2,232
Posted By DH106

Yes, it's the older black rectangular GSU. I also...

Yes, it's the older black rectangular GSU. I also have one of the mini-onboard GSU units, but its buttons are the same as the black GSU.
I'll try and source some Festo 3mmOD tube then - it's not...
Forum: JetCat Turbine Direct Support
02-27-2020, 02:12 PM
Replies: 12
Views: 2,232
Posted By DH106

Ah - okay, perhaps the tubing I'm using is too...

Ah - okay, perhaps the tubing I'm using is too narrow & restrictive at 2mm ID and that's the problem.
Ref: the GSU - there doesn't seem to be a [Set] button on mine, could this be the [Change Value]...
Forum: JetCat Turbine Direct Support
02-27-2020, 01:41 PM
Replies: 12
Views: 2,232
Posted By DH106

Thanks for the advice Dave - I'll try that...

Thanks for the advice Dave - I'll try that tomorrow.
Pretty sure there's no restriction in the fuel system - the fuel piping is new, but it's the same 3mm OD/2mm ID as the original tubing supplied...
Forum: JetCat Turbine Direct Support
02-27-2020, 07:48 AM
Replies: 12
Views: 2,232
Posted By DH106

JetCat Pump Power

I have a JetCat P20 which I'm running on a test stand, but it no longer reaches it's full power RPM of 245K - it gets to about 215K, although the 'commanded RPM' shown in the lower right of the GSU...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.