RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: paphman
Showing results 1 to 12 of 12
Search took 0.02 seconds.
Forum: RC Warbirds and Warplanes
02-16-2022, 06:53 PM
Replies: 787
Views: 270,819
Posted By paphman

I am using a Dualsky GA4000 (180kv) motor,...

I am using a Dualsky GA4000 (180kv) motor, CC160HV esc swinging a 21x12 prop. 2 x ChinaHobbyLine 6s 70c 5000mah, 2 x 2s 1300mah battery for receiver with redundancy and 2s 1300mah for the Robart...
Forum: RC Warbirds and Warplanes
08-03-2020, 11:36 PM
Replies: 787
Views: 270,819
Posted By paphman

I bought this battery tray from Gator RC....

I bought this battery tray from Gator RC. https://gator-rc.com/airplane-accessories/warbird-replacement-parts/spitfire-parts/custom-slide-in-lipo-tray-for-the-toprcmodel-spitfire
This battery tray...
Forum: RC Warbirds and Warplanes
08-02-2020, 11:49 PM
Replies: 787
Views: 270,819
Posted By paphman

Maidened the Spitfire 5 days ago. Perfect...

Maidened the Spitfire 5 days ago. Perfect condition for the maiden.
AUW 23 lb. Has to add 3 lb of lead at the front. Flying with a Dualsky G4000 180kv electric motor and 12S 70C 5,000mAh batteries...
Forum: RC Warbirds and Warplanes
03-18-2018, 06:43 PM
Replies: 787
Views: 270,819
Posted By paphman

It might have been mentioned in previous posts. ...

It might have been mentioned in previous posts.
Is the 130mm from the leading edge described in the manual good to be set as the CG point? If it is, I roughly need to add 2.5 lb nose weight. Does...
Forum: RC Warbirds and Warplanes
02-24-2018, 01:15 AM
Replies: 787
Views: 270,819
Posted By paphman

Thanks. I got it done tonight and looks good.

Thanks. I got it done tonight and looks good.
Forum: RC Warbirds and Warplanes
02-23-2018, 12:47 AM
Replies: 787
Views: 270,819
Posted By paphman

I come to the point installing the exhausts in...

I come to the point installing the exhausts in the cowling. After I put the exhaust pipes through the holes in the cowling at both sides, the cowling cannot be installed properly over the motor...
Forum: RC Warbirds and Warplanes
02-18-2018, 02:52 PM
Replies: 787
Views: 270,819
Posted By paphman

Thanks for the advice. I have 6s GensAce 60c...

Thanks for the advice.
I have 6s GensAce 60c 5,000mah batteries, I'll check again if I can put them parallel after I dremel out the bulkhead.
If not, I just go with the 10s set up.
Forum: RC Warbirds and Warplanes
02-17-2018, 02:30 PM
Replies: 787
Views: 270,819
Posted By paphman

Start putting together this plane slowly for...

Start putting together this plane slowly for electric set up. I was planning to use 12s 5,000mAh battery since nose weight is needed. But the motor box is too small for 2x6s battery side by side.
It...
Forum: RC Warbirds and Warplanes
01-07-2018, 03:05 PM
Replies: 787
Views: 270,819
Posted By paphman

Thanks.

Thanks.
Forum: RC Warbirds and Warplanes
01-06-2018, 09:22 PM
Replies: 787
Views: 270,819
Posted By paphman

​​​​​​I need to buy those Robart gear door...

​​​​​​I need to buy those Robart gear door mounting brackets. Are your wheels parallel to the well when they are retracted inside the well or tilted at an angle?
Forum: RC Warbirds and Warplanes
01-06-2018, 08:54 PM
Replies: 787
Views: 270,819
Posted By paphman

I bought the plane from Tower Hobbies. The...

I bought the plane from Tower Hobbies. The instruction manual shows a couple of brackets holding the struts and screw the door to the brackets.
But I cannot find them in the accessories included...
Forum: RC Warbirds and Warplanes
01-06-2018, 08:07 PM
Replies: 787
Views: 270,819
Posted By paphman

Hi All, I need some help on the installation of...

Hi All,
I need some help on the installation of the landing gear retracts/struts and wheel cover. I bought a set of Robart electric retracts and struts set for this plane.
Due to the geometry of...
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.